CVT Transaxle System: CVTF: Inspection
CAUTION:
- When inspecting CVTF level, observe the specified CVTF temperature.
- Do not add CVTF at a cold condition since the oil may blow out.
NOTE:
When there is no severe conditions or intrusion of water, etc., replacement of CVTF is unnecessary.
- Prepare the CVTF for refiling.
- Connect the Subaru Select Monitor.
- Turn the ignition switch to ON. (Engine OFF)
- Display [ATF Temp.].
- Start the engine and raise [ATF Temp.] to 35 - 45 °C (95 - 113 °F).CAUTION: Make sure to perform the CVTF level inspection within [ATF Temp.] of 35 - 45 °C (95 - 113 °F).
- Operate the select lever in P → R → N → D and D → N → R → P to circulate CVTF with the engine idling.
- With the engine idling, lift up the vehicle and remove the filler plug.NOTE:
- CVTF is at the specified level when it is up to the bottom of the filler plug hole.
- Prepare the container for draining of engine oil.
- If the CVTF level is below the bottom of the filler plug hole, check for oil leakage, and add specified CVTF.CAUTION: Always use specified CVTF. Using fluid other than specified CVTF will cause malfunction.
CVTF: Ref. to RECOMMENDED MATERIALS .
- Using a new gasket, install the filler plug.
Tightening torque:
50 N.m (5.1 kgf-m, 36.9 ft-lb)