LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2021 >> Outback Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Power Rear Gate System >> Power Rear Gate Control Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Rear Gate Control Module: Installation

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  • Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.
  • When the power rear gate control module is replaced, set the memory height function again. (Refer to owner's service information for details.)
  1. Install the power rear gate control module.
    NOTE: Connect the connectors in reverse order of removal  .
  2. Install the bracket remote lever LH.

    Tightening torque:

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  3. Install the trim panel assembly D pillar LH and the trim panel assembly apron LH. Ref. to EXTERIOR/INTERIOR TRIM>REAR QUARTER TRIM>INSTALLATION .
  4. Install the rear seat cushion assembly. Ref. to SEATS>REAR SEAT>INSTALLATION .
  5. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals