Inlet Engine Coolant Temperature Sensor
- Install the inlet engine coolant temperature sensor to the harness stay.CAUTION: If the clip of the inlet engine coolant temperature sensor harness is damaged, replace it with a new inlet engine coolant temperature sensor.
- Place a new gasket and install the inlet engine coolant temperature sensor.
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Install the inlet engine coolant temperature sensor stay with the bolt (C).
Tightening torque:
8.5 N.m (0.9 kgf-m, 6.3 ft-lb)
- Install the connector (B) to the chain cover and connect the connector (A).CAUTION:
- If the clip (a) of the connector (B) is damaged, replace it with a new clip.
- If the installation part for the clip (a) of the connector (B) is damaged, replace it with a new inlet engine coolant temperature sensor.
- If the clip (a) has been replaced, put a marking (b) to ensure that the replacement of clips can be identified.
- Install the front exhaust pipe. Ref. to EXHAUST (H4DO)>FRONT EXHAUST PIPE>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Fill engine coolant. Ref. to COOLING (H4DO)>ENGINE COOLANT>REPLACEMENT>FILLING OF ENGINE COOLANT .