Repair Contents: Note: Towing
Avoid towing vehicles except when the vehicle cannot be driven. Use a loader instead of towing. When towing other vehicles, pay attention to the following to prevent hook or vehicle damage resulting from excessive weight.
- Make sure the vehicle towing is heavier than the vehicle being towed.
- When towing the vehicle equipped with Subaru EyeSight, be sure to hold down the pre-collision brake OFF switch to turn OFF the pre-collision brake function. (Check that the pre-collision brake OFF indicator light in the meter lights up.)
- Front (sedan model)
When towing the vehicle, always tow it in rear direction because the towing hook (eyebolt) installation hole is not provided to this vehicle.
CAUTION:
Do not tow using front tie-down hooks.
NOTE:
Towing hook (eyebolt) is not a standard equipment.
- Front (OUTBACK model)
Remove the hook cover, and install the towing hook (eyebolt).
CAUTION:
- Make sure to detach the towing hook (eyebolt) after towing. If the hook remains attached, airbag may not operate properly when receiving a shock from front side. And it may also affect the crash performance of the vehicle.
- Do not tow using front tie-down hooks.
- Rear
Remove the hook cover, and install the towing hook (eyebolt).
CAUTION:
Make sure to detach the towing hook (eyebolt) after towing. If the hook remains attached, the fuel leakage control function of the fuel pump may not operate properly when receiving a shock from rear side. And it may also affect the crash performance of the vehicle.
NOTE:
For sedan models, the towing hook (eyebolt) is not a standard equipment.
- Precautions
| Towing method | Precautions | CVT |
|---|---|---|
| Lifting up four wheels (on a trailer) | Towing the vehicle after lifting up all four wheels is a basic rule. | ◦ |
| Rope |
|
Δ |
| Raising the front wheels | Towing the vehicle after lifting up all four wheels is a basic rule. | x |
| Lifting up the front wheels |
|
x |
Marked ◦: OK, Marked x: Prohibited, Marked Δ: Conditionally OK
CAUTION:
- Place the shift lever in "N" position during towing.
- Do not lift up the rear wheels to avoid unsteady rotation.
- Turn the ignition switch to "ACC", then check that the steering wheel moves freely. (Model without keyless access with push button start)
- Turn the ignition switch to "ACC" or "ON" position, and check that the steering wheel moves freely. (Model with keyless access with push button start)
- Release the parking brake to avoid tire dragging.
- Since the power steering does not work, be careful for the heavy steering effort. (When engine is stopped)
- Since the servo brake does not work, be careful that the brake is not applied effectively. (When engine is stopped)
- In case of the malfunction of internal transmission or drive system, lift up four wheels (on a trailer) for towing.
- Do not use towing hook (eyebolt) except when towing.
- While being towed with all four wheels on the ground, turn the engine switch to ON but do not start the engine.
- If any of the following conditions is met, the headlight beam may deviate. If the headlight beam deviates, perform fuse resetting. Ref. to LIGHTING SYSTEM>AUTO HEADLIGHT BEAM LEVELER SYSTEM>PROCEDURE>FUSE RESET .
- Difference has occurred to the angle of road surface between when the ignition switch is turned to OFF and when the ignition switch is turned to ON.
- Difference has occurred to the angle of road surface between when the ignition switch is turned to OFF and when the vehicle speed is 0 km/h (0 MPH).