Belt Assembly Front Out

CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.
The parts of the driver and passenger sides are not the same. Before installation, make sure that the correct part is used.
During installation, make sure that the seat belts are not twisted.
After installation, make sure that the seat belt can be pulled out and retracted smoothly.
Make sure that the seat belt harness is not caught anywhere. Wrong harness rooting may cause the harness short from pinch.
Do not reuse the clips on the top of the trim panel assembly B pillar UPR. Once the clip is removed, its holding force is reduced. Be sure to replace it with a new clip.

Before installation, perform a unit inspection of retractor. Ref. to SEAT BELT SYSTEM>FRONT SEAT BELT>INSPECTION .
Install the adjuster shoulder anchor.
Tightening torque:

53 N.m (5.4 kgf-m, 39.1 ft-lb)
Install the retractor part and the shoulder anchor part of the belt assembly front OUT.
Tightening torque:

Refer to "COMPONENT" of "General Description" for the tightening torque. Ref. to SEAT BELT SYSTEM>GENERAL DESCRIPTION>COMPONENT>FRONT SEAT BELT .
Install the trim panel assembly B pillar UPR.
Tightening torque

Trim panel assembly B pillar UPR: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the lower anchor bolt of the belt assembly front OUT.
Tightening torque

30 N.m (3.1 kgf-m, 22.1 ft-lb)
Install the trim panel assembly B pillar LWR, cover side sill rear UPR, weather strip body side flange, and cover side sill front Rr.
NOTE: Assemble the trim panel assembly B pillar LWR and the trim panel assembly B pillar UPR securely.
Install the rear seat cushion assembly.
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
After installation, check the following points.
- The seat belt is not twisted.
- The seat belt can be pulled out and retracted smoothly.
- The adjuster shoulder anchor can be moved smoothly.
- Check that the airbag warning light lights up for approximately 6 seconds and then turns off when connecting the ground terminal to the battery sensor and turning the ignition switch to ON.