| Fuel Pump Relay |
ON/OFF of the fuel pump can be set. |
Ignition switch ON (engine OFF) |
| CPC Solenoid Valve |
ON/OFF of the purge control solenoid valve can be set. |
| Radiator Fan Relay |
ON/OFF of the radiator fan motor can be set. |
| ELCM switching valve |
ON/OFF of the leak check valve assembly switching valve can be set. |
| ELCM pump |
ON/OFF of the leak check valve assembly vacuum pump can be set. |
| Fuel Pump Control (OFF Drive) |
Fuel pump can be set to OFF. |
- Idling
- Select lever is in "P" range or "N" range.
- Vehicle speed 0 km/h (0 MPH)
|
| Fixed Idle Ignition Timing |
Idle ignition timing can be set according to engine speed. |
| Idle Speed Control |
Idle speed can be set. |
| Injection Stop Mode (Injector 1) Injection Stop Mode (Injector 2) Injection Stop Mode (Injector 3) Injection Stop Mode (Injector 4) |
Injector of each cylinder can be set to stop the fuel injection. |
| Injection Quantity Control |
The amount of fuel injection can be set. |
| EGR Valve Control (Step) |
STEP number of the EGR control valve can be set. |
| High Pressure Fuel Inspection |
High pressure fuel pipe inspection can be executed. |
| Alternator control |
Alternator control mode can be set to one of the followings:
- Low mode
- Middle mode
- High mode
- Ex. High mode
|
| Compression monitor |
Compression can be measured. |
- Ignition switch ON (engine OFF)
- Accelerator pedal is fully depressed
|
| Electric Air Bypass Valve Control |
Switch OPEN/CLOSE of electronic air by-pass valve every 3 seconds. |
Ignition switch ON (engine OFF) |
| Electric Waste Gate Valve Control |
Switch OPEN/CLOSE of electronic wastegate valve every 3 seconds. |
Ignition switch ON (engine OFF) |