Select Lever: Removal

NOTE: Shift lock solenoid and "P range" switch cannot be disassembled.

Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Remove the mat center tray.

Courtesy of SUBARU OF AMERICA, INC.
Release the shift lock using a screwdriver, etc. and shift the select lever to the "N range".

Courtesy of SUBARU OF AMERICA, INC.
Lower the section (A) of the boot.

Courtesy of SUBARU OF AMERICA, INC.
Remove the clamp (A) and remove the grip.

Courtesy of SUBARU OF AMERICA, INC.
Remove the boot.

Courtesy of SUBARU OF AMERICA, INC.
Remove the cover center side RH and the cover center side LH. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CONSOLE>REMOVAL
Remove the duct console center. (Models with rear seat air conditioning) Ref. to REMOVAL .
Remove the select cable. Ref. to CONTROL SYSTEMS>SELECT CABLE>REMOVAL .
Disconnect the connector.

Courtesy of SUBARU OF AMERICA, INC.
Remove the bolts which secure the select lever.

Courtesy of SUBARU OF AMERICA, INC.
Remove the clip securing the harness, and remove the select lever.
- Model without CD deck
Courtesy of SUBARU OF AMERICA, INC.
- Model with CD deck
Courtesy of SUBARU OF AMERICA, INC.