LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (2.0L) >> Rear Oxygen Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Oxygen Sensor: Removal

  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Lift up the vehicle.
  3. Remove the under cover. Refer to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>REMOVAL .
  4. Disconnect the connector on the rear oxygen sensor from the engine wiring harness.
    G10266247Courtesy of SUBARU OF AMERICA, INC.
  5. Apply spray-type lubricant (004301003) to the threaded portion of rear oxygen sensor, and leave it for one minute or more.
  6. Remove the rear oxygen sensor.
    CAUTION: When removing the rear oxygen sensor, wait until exhaust pipe cools, otherwise it will damage the exhaust pipe.
    G10266248Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals