Front Brake Hose

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.

Secure the brake hose front to the brake hose mount part of strut COMPL front.
Tightening torque:

33 N.m (3.4 kgf-m, 24.3 ft-lb)
Install the brake hose front to the caliper body using a new gasket.
Tightening torque:

26 N.m (2.7 kgf-m, 19.2 ft-lb)
Check that the steering wheel is in the straight-ahead position and route the brake hose front through the hole in the bracket on the wheel apron side.
CAUTION:
Do not twist the brake hose front.
Connect the pipe assembly front ABS and brake hose front, and temporarily install the flare nut.
Secure the brake hose front to wheel apron bracket with the clamp brake hose.
Install the pipe assembly front ABS.
CAUTION:
Be careful not to make scratches or other damage to the inside surface of the brake pipe flare.
1. Turn and tighten the flare nut (b) by hand while pushing the pipe assembly front ABS (a) away from yourself.
2. Tighten the flare nut (b) using a flare nut wrench and a crowfoot wrench.
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

Calculation formula

T = 15 N.m (1.5 kgf-m, 11.1 ft-lb) x L1/(L1 + L2)

T: Reading of the torque wrench

L1: Effective length of the torque wrench

L2: Effective length of the crowfoot wrench

NOTE:
If the effective length of the tool used is unknown, consult the manufacturer of the tool.

Courtesy of SUBARU OF AMERICA, INC.
Bleed air from the brake system. Ref. to BRAKE>AIR BLEEDING>PROCEDURE .
Install the front wheels. Ref. to WHEEL AND TIRE SYSTEM>TIRE AND WHEEL>INSTALLATION .