Stop Light Switch: Installation
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- Install the stop light switch assembly onto the bracket COMPL pedal and position it with the nut.
- Adjust the stop light switch assembly position, and then tighten the nut. Ref. to BRAKE>STOP LIGHT SWITCH>ADJUSTMENT>CLEARANCE ADJUSTMENT .
Tightening torque:
8 N.m (0.8 kgf-m, 5.9 ft-lb)
- Connect the stop light switch assembly connector.
- Install the duct foot driver. Ref. to AIR CONDITIONER>AIR VENT DUCT>INSTALLATION>FOOT DUCT .
- Install the knee airbag module. Ref. to AIRBAG SYSTEM>KNEE AIRBAG MODULE>INSTALLATION .
- Install the cover LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .