LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Transmission Control System) >> Select Lever >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Lever: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the select cable to the select lever. Ref. to CONTROL SYSTEMS>SELECT CABLE>INSTALLATION .
  2. Install the select lever.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb)

  3. Install the clip securing the harness.
  4. Connect the connector.
    G14602396Courtesy of SUBARU OF AMERICA, INC.
  5. Connect the select cable to the transmission main body. Ref. to CONTROL SYSTEMS>SELECT CABLE>INSTALLATION .
  6. Install the cover center side. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CONSOLE>INSTALLATION .
  7. Install the clamp to the grip.
    NOTE:

    Insert it from the front side. 

  8. Install the grip.
    NOTE:

    Install it while pressing on the clamp. 

  9. Install the boot to the grip.
  10. Release the shift lock using a screwdriver, etc. and shift the select lever to the "P range".
  11. Install the mat center tray.
  12. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals