Select Cable: Removal

Shift the select lever to "N" range.
Disconnect the ground cable from battery. Refer to NOTE>NOTE>BATTERY .
NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
Lift up the vehicle.
Remove the center exhaust pipe (rear). Refer to EXHAUST(W/O STI)>CENTER EXHAUST PIPE>REMOVAL .
Remove the center exhaust cover.

Courtesy of SUBARU OF AMERICA, INC.
Remove the snap pin and washer from the shifter arm.
CAUTION: Do not apply extra overload while holding the part (a).

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.
Remove the plate assembly.

Courtesy of SUBARU OF AMERICA, INC.
Disconnect the cable from arm COMPL.
CAUTION: Do not apply extra overload while holding the part (a).

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.
Raise the claw of clamp and remove the cable.

Courtesy of SUBARU OF AMERICA, INC.
Remove the select cable from plate assembly.