LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2022 >> Ascent Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System >> Engine Wiring Harness >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Wiring Harness: Installation

  1. Set the engine wiring harness to the engine, and connect each connector. Ref. to FUEL INJECTION (FUEL SYSTEM) (H4DOTC)>General Description>COMPONENT>ENGINE WIRING HARNESS .
    NOTE:
    • If the clip is damaged, replace it with a new part.
    • Before replacing the clip, put an alignment mark (a) on both engine wiring harness and clip to remove the clip, and then align to the alignment mark (a) to attach a new clip to the engine wiring harness.
    G13198268Courtesy of SUBARU OF AMERICA, INC.
  2. Install the fuel insulator. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Fuel Insulator>INSTALLATION .
  3. Install the intake manifold assembly. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Intake Manifold Assembly>INSTALLATION .
  4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals