Intermediate Case: Installation

Clean the mating surface of intermediate case and transmission case.
Face the O-ring side of the CVTF filter to the intermediate case side, and install the CVTF filter.
CAUTION:
- Apply sufficient amount of CVTF to the O-rings in order to avoid damage and deformation.
- Use SUBARU genuine CVTF.
Courtesy of SUBARU OF AMERICA, INC.
Install a new O-ring to the transmission case.
CAUTION:
- Before installing O-rings, apply sufficient amount of CVTF to avoid damage and deformation.
- Use SUBARU genuine CVTF.
- Be careful not to incorrectly install or fail to install O-rings and other such parts.
Apply liquid gasket to intermediate case mating surface seamlessly, and temporarily install it.
Liquid gasket:

THREE BOND 1215B or equivalent

Courtesy of SUBARU OF AMERICA, INC.
Install the transmission hanger, and tighten the intermediate case mounting bolts.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install the transfer reduction driven gear. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Transfer Reduction Driven Gear>INSTALLATION .
Install the transfer clutch. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Transfer Clutch>INSTALLATION .
Install the rear drive shaft. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Rear Drive Shaft>INSTALLATION .
Install the parking pawl. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Parking Pawl>INSTALLATION .
Install the extension case. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Extension Case>INSTALLATION .
Install the transmission body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Transmission Assembly>INSTALLATION .