Clear memory: Operation

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, input the target vehicle information and select [OK].
On [Main Menu] screen, select [Each System].
On [Select System] screen, select the corresponding system and select [Enter].
On [Select Function] screen, select [DTC].
On [DTC] screen, select [Clear memory].
NOTE:
- For detailed operation procedures, refer to "Help" of application.
- When using the Subaru Select Monitor, turn the ignition switch to ON.
- Sub screen may appear in the system selection display. In that case, select appropriate items in accordance with the contents of the display.
- When the clear memory is performed, diagnostic code (DTC) and freeze frame data (FFD) necessary in diagnosis will also be deleted.
- Before performing the clear memory, be sure to save the diagnostic code (DTC) and freeze frame data (FFD) stored in the module.
- After performing the clear memory, be sure to turn the ignition switch to OFF, and wait for the number of seconds indicated on the Subaru Select Monitor screen before turning the ignition switch to ON.
- Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.