Belt Assembly Front Inn
CAUTION:
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- Before installation, make sure that the correct part is used.
- During installation, make sure that the seat belts are not twisted.
- Check that there is no pinching of the seat belt harness. Wrong harness rooting may cause the harness short from pinch.
- Do not forget the spring wave washer, when installing the belt assembly front INN.
- If the passenger's seat is removed, be sure to perform [Rezeroing] for the occupant detection system after installing the seat to the vehicle. Ref. to OCCUPANT DETECTION (DIAGNOSTICS)>REZERO .
- For model with door mirror interlocked seat position memory, initialize the power seat & remote control CM after installing the driver's seat in the vehicle if the seat has been removed. Ref. to SEATS>POWER SEAT SYSTEM>ADJUSTMENT .
- Install the belt assembly front INN.
- Install the wave washer, belt assembly front INN and nut in order and then tighten the nut.
Tightening torque:
38 N.m (3.9 kgf-m, 28.0 ft-lb)
- Locate the seat belt harness and retain it with a harness clip.
NOTE: For details about harness routing behind the seat, refer to "SEATS" section. Ref. to SEATS>FRONT SEAT>ASSEMBLY>CONNECTOR & HARNESS . - Install the wave washer, belt assembly front INN and nut in order and then tighten the nut.
- Install the front seat to the vehicle body. Ref. to SEATS>FRONT SEAT>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .