Crankshaft Position Sensor: Removal

Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Remove the clip from the air intake boot, and loosen the clamp.

Courtesy of SUBARU OF AMERICA, INC.
Remove the air intake boot, and place it aside so that it does not interfere with the work.
CAUTION:
Be careful not to pull out the PCV hose.

Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector (A).
Remove the bolt securing the engine ground and the harness case.
Remove the clip (B) from the engine wiring harness bracket.

Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector (A) and remove the crankshaft position sensor.

CAUTION:

Do not apply excessive force to the harness. Otherwise the harness may be damaged.

Courtesy of SUBARU OF AMERICA, INC.