Active Test: List
NOTE:
- Before performing the active test for Auto Start Stop, execution conditions listed below must be met in each item.
- *: The restart conditions after stopping the engine are the same as that of "Auto Start Stop restart conditions". Ref. to AUTO START STOP (DIAGNOSTICS)>DATA MONITOR>LIST .
| Active test item | Contents | Execution condition |
|---|---|---|
| Electric oil pump control (Relay ON/OFF drive) | ON/OFF of the electric oil pump relay (Auto Start Stop) can be set. |
|
| Electric oil pump control (Pump ON/OFF drive) | Command duty of the electric oil pump (Auto Start Stop) can be set to 10 → 65% (for 120 seconds). |
|
| Sub power supply control (ON/OFF Dr.) | DC/DC converter can be set to ON (2 seconds). | "Common execution condition" established |
| Engine stop control* | Auto Start Stop can be performed without driving the vehicle. | Auto Start Stop condition is established Ref. to AUTO START STOP (DIAGNOSTICS)>DATA MONITOR . |
Common execution condition
- CAN communication for engine is normal.
- Following conditions are established
| Item | Value |
|---|---|
| Ignition Switch(Auto Start Stop) | ON |
| System Voltage(Auto Start Stop) | 12.1 V or more |
| Engine Speed(Auto Start Stop) | 0 rpm |
| Vehicle Speed | 0 km/h (0 MPH) |
| Idling Stop Control | Other than during control |