LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2022 >> Outback Touring >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transmission Control System >> Select Lever >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Lever: Installation

  1. Install the select cable to the select lever. Ref. to CONTROL SYSTEMS>SELECT CABLE>INSTALLATION 
  2. Install the clip which holds the harness, and set the select lever.
  3. Install the bolt which holds the select lever.

    Tightening torque: 

    18 N.m (1.8 kgf.m, 13.3 ft.lb)

  4. Connect the connector.
  5. Connect the select cable to the transmission main body. CONTROL SYSTEMS>SELECT CABLE>INSTALLATION .
  6. Install the duct console center. (Models with rear seat air conditioning) Ref. to AIR CONDITIONER>AIR VENT DUCT>INSTALLATION>CONSOLE DUCT>CENTER .
  7. Install the cover center side RH and the cover center side Ref. to EXTERIOR/INTERIOR TRIM>CENTER CONSOLE>INSTALLATION .
  8. Install the boot to the indicator assembly.
  9. Install the clamp to the grip.
    NOTE: Insert it from the front side.
  10. Install the grip.
    NOTE: Install it while pressing on the clamp.
  11. Install the boot to the grip.
  12. Install the mat center tray.
  13. Shift the select lever to "P range".
  14. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals