LH Side

Using a claw-foot wrench, install the knock sensor and connect the connector (A).

NOTE:

Knock sensor must be positioned so that the connector center comes within the range shown in the figure.

Make sure that the knock sensor and its connector do not touch the adjacent parts.

Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

Calculation formula

T = 24 N.m (2.4 kgf-m, 17.7 ft-lb) x L1/(L1 + L2)

T: Reading of the torque wrench
L1: Effective length of the torque wrench
L2: Effective length of the crowfoot wrench

NOTE:

If the effective length of the tool used is unknown, consult the manufacturer of the tool.

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.

Install the connector (A) and clip (B).

Courtesy of SUBARU OF AMERICA, INC.
Install the clip (C), clip (D) and clip (E), and connect connector (A) and connector (B). (CVT model)

Courtesy of SUBARU OF AMERICA, INC.
Install the intercooler. Ref. to INTAKE (INDUCTION) (H4DOTC)>INTERCOOLER>INSTALLATION
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY