Body Control

NOTE: Other than for C0 model

IMMOBILIZER SYSTEM (BODY CONTROL) DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION

DTC	Reference
B1402	Ref. to IMMOBILIZER (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC B1402 IMMOBILIZER KEY COLLATION
B1403	Ref. to IMMOBILIZER (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC B1403 IMMOBILIZER SUB CONTROL MODULE COLLATION
B1404	Ref. to IMMOBILIZER (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC B1404 IMMOBILIZER SUB CONTROL MODULE COMMUNICATION
B140A	Ref. to IMMOBILIZER (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC B140A IMMOBILIZER SUB CONTROL MODULE NON-VOLATILE MEMORY
B1410	Ref. to IMMOBILIZER (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC B1410 TRANSPONDER COMMUNICATION
B1411	Ref. to IMMOBILIZER (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC B1411 IMMOBILIZER ANTENNA

NOTE: The starter relay control is performed in immobilizer system. When the body integrated unit detects a nonconformity of reference code, it immediately outputs a starter relay cut signal to ECM, and then ECM stops the starter relay operation. In this case, engine does not start, and DTC is not recorded in ECM. Therefore, check DTC on the body integrated unit to identify the cause of the engine not starting.