Fuel Injector RH
CAUTION:
- Be careful not to spill fuel.
- Catch the fuel from the pipes using a container or cloth.
- Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Remove the high-pressure fuel delivery pipe assembly. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>HIGH PRESSURE FUEL DELIVERY PIPE>REMOVAL>HIGH-PRESSURE FUEL DELIVERY PIPE ASSEMBLY .
- Disconnect the connector (A) from the fuel pressure sensor.
- Disconnect the connector (B) from fuel injector #1, and remove the fuel injector pipe.CAUTION: Pull out the assembly straight so that the seal surface of the fuel injector pipe RH is not damaged.
- Remove the holder from the fuel injector assembly.
- Using ST, remove the fuel injector assembly from the cylinder head.
- Set the ST to the fuel injector #1.NOTE: Do not use the ST adapter for the fuel injector #3.
Preparation tool:
ST: ADAPTER R (18362AA060)
- Pinch the fuel injector groove (B) with the claw (A) of the ST.
Preparation tool:
ST: INJECTOR REMOVER (18356AA010)
- Press the ST to the cylinder head.
- Screw in the threaded section of the ST clockwise, and remove the fuel injector assembly from the cylinder head.CAUTION:
- If the tip of the fuel injector assembly is hit or the assembly is dropped, replace the fuel injector assembly with a new part.
- Identify the removed fuel injector assembly with a tag etc. marked with the cylinder number.
Preparation tool:
ST: INJECTOR REMOVER (18356AA010)
- Set the ST to the fuel injector #1.