Belt Assembly Front Inn

CAUTION:

Before installation, make sure that the correct part is used.
Make sure that the seat belt harness is not caught anywhere. Wrong harness rooting may cause the harness short from pinch.
If the passenger's seat is removed, be sure to perform [Rezero] for the occupant detection system after installing the seat to the vehicle.
Do not forget the spring wave washer, when installing the belt assembly front INN.
Attach unwoven cloth of the spring wave washer with the cloth facing downward.
Apply grease to the bolt stepped section (a) and the stopper section (b) when replacing the belt assembly front INN.
Do not apply grease to the thread and the nut tightening surface (c).

Use grease not containing silicone. Vaporized silicone may adhere to the electrical contact and lead to poor continuity.

Preparation items:

Grease: IDEMITSU APOLLOIL AUTOLEX A or equivalent Ref. to RECOMMENDED MATERIALS>GREASE .

Courtesy of SUBARU OF AMERICA, INC.

Install the belt assembly front INN.
1. Install the wave washer, belt assembly front INN and nut in order and then tighten the nut.
  Tightening torque:
  
  38 N.m (3.9 kgf-m, 28.0 ft-lb)
2. Locate the seat belt harness and retain it with a harness clip.
Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.

NOTE: For details about harness routing behind the seat, refer to "SEATS" service information . Ref. to SEATS>FRONT SEAT>ASSEMBLY .
Install the seat assembly to the body. Ref. to SEATS>FRONT SEAT>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
If the passenger's seat is removed, perform [Rezero] in the occupant detection system. Ref. to OCCUPANT DETECTION (DIAGNOSTICS)>REZERO .