Select Cable: Adjustment

Release the shift lock and shift the select lever to the "N range". Ref. to CONTROL SYSTEMS>SELECT LEVER>REMOVAL .
Remove the center exhaust cover (front). Ref. to EXHAUST (H4DOTC)>REAR EXHAUST PIPE>REMOVAL .
Loosen the adjusting nut (front) and adjusting nut (rear).

Courtesy of SUBARU OF AMERICA, INC.

Turn the adjusting nut (front) until it lightly touches the connector pin.

Courtesy of SUBARU OF AMERICA, INC.

While holding the adjusting nut (front) in place, tighten the adjusting nut (rear).
Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
After the completion of adjustment, check that the select lever operates normally at all ranges.
Install the center exhaust cover (front). Ref. to EXHAUST (H4DOTC)>REAR EXHAUST PIPE>INSTALLATION .
Release the shift lock and shift the select lever to the "P range". Ref. to CONTROL SYSTEMS>SELECT LEVER>INSTALLATION .