Active Test: List

Active test item	Contents	Execution condition
Fuel Pump Relay	ON/OFF of the fuel pump can be set.	Ignition switch ON (engine OFF)
CPC Solenoid Valve	ON/OFF of the purge control solenoid valve can be set.
Radiator Fan Relay	ON/OFF of the radiator fan relay can be set.
ELCM switching valve	ON/OFF of the leak check valve assembly switching valve can be set.
ELCM pump	ON/OFF of the leak check valve assembly vacuum pump can be set.
Fuel Pump Control (OFF Drive)	Fuel pump can be set to OFF.	Idling
Fixed Idle Ignition Timing	Idle ignition timing can be set according to engine speed.	Idling
Idle Speed Control	Idle speed can be set.	Idling
Injection Stop Mode (Injector 1) Injection Stop Mode (Injector 2) Injection Stop Mode (Injector 3) Injection Stop Mode (Injector 4)	Injector of each cylinder can be set to stop the fuel injection.	Idling
Injection Quantity Control	The amount of fuel injection can be set.	Idling
EGR Valve Control (Step)	STEP number of the EGR control valve can be set.	Idling
High Pressure Fuel Inspection	High pressure fuel pipe inspection can be executed.	Idling
Alternator control	Alternator control mode can be set to one of the followings: Low: Mode that controls the battery charge Mid: Mode where the battery is not charged and discharged High: Mode that fixes the voltage when the battery is charged or when an electric load is turned on ExHigh: Mode where the battery is charged during deceleration	Idling
Compression monitor	Compression can be measured.	Ignition switch ON (engine OFF) Accelerator pedal is fully depressed
Electric Air Bypass Valve Control	Electronic air by-pass valve can be set to ON/OFF.	Idling
Electric Waste Gate Valve Control	Electronic wastegate valve can be opened/closed.	Idling