Diagnostic Trouble Code (DTC): Operation

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, input the target vehicle information and select [OK].
On [Main Menu] screen, select [Each System].
On [Select System] screen, select the corresponding system and select [Enter].
On [Select Function] screen, select [DTC].

NOTE:

For detailed operation procedures, refer to "Help" of application.
When using the Subaru Select Monitor, turn the ignition switch to ON.
Sub screen may appear in the system selection display. In that case, select appropriate items in accordance with the contents of the display.
Current code is a diagnostic code displayed when the system is judging the current code. However, if a DTC is recorded due to poor contact etc., the code remains displayed as current code during the drive cycle even after the poor contact has resolved.
Pending code is a trouble code that displays the malfunction in 1st driving cycle as a temporary malfunction, in the diagnostic code where a malfunction is detected in 2nd driving cycles.
History code is a diagnostic code recorded when the current code is not detected but the system has detected a malfunction in the past. When the current code is recorded, it is also recorded to the history code at the same time.