Other Adjustment Operations Before Delivering The Vehicle To Customer

CAUTION: If the delivery mode fuse is removed, the DTC related to the center information display (CID) is recorded. For the installation procedure of the delivery mode fuse, be sure to refer to "FUSE INSTALLATION" in "Pre-delivery Inspection". Ref. to PRE-DELIVERY INSPECTION>PRE-DELIVERY INSPECTION (PDI) PROCEDURE>FUSE INSTALLATION .

Due to service and parts replacement convenience, perform the following operations before delivering the vehicle to the customer.

No.	Item	Check operation	Adjustment operation	Additional adjustment operations when replacing parts
1	Positions of devices Steering wheel Mirror assembly inner rearview Outer mirror Seat Air vent grille Power rear gate memory height function: Height information	Is the device set to the same position when the vehicle was received from the customer?	Adjust the device to the similar position when the vehicle was received from the customer.	When removing/installing each device Combination meter, instrument panel, steering column, etc. Mirror assembly inner rearview, roof trim, sunroof assembly, etc. Outer mirror, door panel, etc. Seat, floor carpet, etc. Vent grille, instrument panel, console box, etc. Replacement of power rear gate control module
2	Positions of switches Wiper, light (AUTO or OFF) Illumination control Room light Seat heater (front) Power rear gate handsfree OFF SW Power rear gate memory: ON-OFF	Is the switch set to the same position when the vehicle was received from the customer?	Set the switch to the same position when the vehicle was received from the customer.	When removing/installing each switch