MT Gear Shift Cable: Installation

CAUTION: Do not bend the MT gear shift cable more than necessary.

Install the shift bracket.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Apply grease to the shift lever COMPL.
Preparation items:

Grease: NIPPON GREASE NIGTIGHT LTS No. 2 or equivalent

Courtesy of SUBARU OF AMERICA, INC.
Install the MT gear shift cable.
CAUTION:
- Do not twist the cable inner more than necessary.
- Do not apply excessive load while holding the part (a).
Courtesy of SUBARU OF AMERICA, INC.

NOTE: Install the MT gear shift cable with the mark (a) on the cable facing upward.

Courtesy of SUBARU OF AMERICA, INC.
Install the snap pin and washer.
Install the clamp.
CAUTION: Do not hit the MT gear shift cable.
If you hit the MT gear shift cable by mistake, replace it with a new one.
Install the dust cover.
Tightening torque:

15 N.m (1.5 kgf-m, 11.1 ft-lb)
Install the cable clamp.
NOTE: Pass the MT gear shift cable and MT gear select cable through the cable clamp before installing it.

Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Install the transmission body. Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (TY75)>TRANSMISSION ASSEMBLY>INSTALLATION .
Check that the MT gear shift lever can be shifted into each position.