REINITIALIZATION Of Shade Control Module
NOTE:
This work is required when a deviation occurs between the position recognized by the shade control module and the actual position of the shade, resulting from removing/installing the motor assembly that has already been initialized and removing/installing the shade assembly.
- Turn the ignition switch to ON.
- Push the shade switch to the OPEN side, and move the shade assembly to the fully open position.
- Turn the shade switch to OFF once. Push the shade switch to the OPEN side again, and hold it for 10 seconds or more.
- After 10 seconds, the shade assembly moves to the fully open mechanical lock position, and then reverses and stops at the fully open position.
- It stops at the fully open position and the reinitialization of the shade control module will be complete.NOTE: For the operation order of shade assembly reinitialization, refer to the following figure.
| (A) | Fully close position |
| (B) | Intermediate position |
| (C) | Fully open position |
| (D) | Fully open mechanical lock position |
| (a) | Lid ASSY front |
| (b) | Lid ASSY rear |
| (c) | Shade ASSY |