Engine Control Module (ECM): Installation

CAUTION: When replacing the ECM, be sure to perform VIN registration, module registration and immobilizer registration after the service.

NOTE: When replacing the ECM, be careful not to use the ECM of wrong specification to avoid any damage on the fuel injection system.

Install the ECM bracket.
Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Temporarily install the ECM to the vehicle, tighten the fasteners in numerical order as shown in the figure.
Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

Fig 1: ECM Fasteners Tightening Sequence
Courtesy of SUBARU OF AMERICA, INC.
Connect the connector in numerical order as shown in the figure.

Courtesy of SUBARU OF AMERICA, INC.
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
When the ECM is replaced
1. Perform [Entry VIN]. Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>WORK SUPPORT>OPERATION .
2. Perform [Module registration]. Ref. to COMMON (DIAGNOSTICS)>UNIT REGISTRATION>OPERATION .
3. Perform the registration of immobilizer.
  NOTE: Refer to the "REGISTRATION MANUAL FOR IMMOBILIZER".

	Model without keyless access with push button start	Model with keyless access with push button start
Other than for C0	Type G	Type H
For C0	Type I	Type H