LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2024 >> Ascent Base >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Airbag System >> Airbag Control Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Airbag Control Module: Installation

  1. Before installation, inspect the following items and replace any faulty part with a new part.
    • Control module is deformed.
    • Control module connector is damaged.
  2. Install the airbag control module.
    CAUTION: Do not reuse the bolt and nut.
    Always replace with the specified new bolts and nuts.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

  3. Install the duct rear heater front.
  4. Install the cover center socket.
  5. Install the cover center side.
  6. Install the console box assembly and the cover assembly front.

    Tightening torque: 

    Console box: 6.5 N.m (0.7 kgf-m, 4.8 ft-lb)

  7. Install the center information display assembly. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY>INSTALLATION .
  8. Install the grille ventilation assembly center. Ref. to AIR CONDITIONER>AIR VENT GRILLE>INSTALLATION>CENTER GRILLE ASSEMBLY .
  9. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: After connecting the ground terminal to the battery sensor, place the select lever in the "P" position.
scientia non olet · About LEMON Manuals