Select Cable: Installation
CAUTION:
- Check that the protector (b) is set between the clamps (a).
- If the protector (b) is offset, set it between the clamps (a).
- Install the cable bracket.CAUTION: Be careful not to twist the boot.
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Set a new clamp on the select lever as shown in the figure.
(A) Front side (B) Upside - Install the select cable to the select lever. (If the connector pin is not removed)CAUTION: Install the cable so that it does not twist.
Check that the select lever is in "N range"
If the connector pin is removed, always replace with a new connector pin.
Do not apply excessive load while holding the part (a).
- Insert the select cable to the connector pin.
- Secure the select cable to the clamp.
- Install the select cable to the select lever. (If the connector pin is removed)CAUTION:
- Install the cable so that it does not twist.
- Check that the select lever is in "N range".
- Do not apply excessive load while holding the part (a).
- Temporarily Install the adjusting nut (rear) to the select cable.
- Apply grease to the shifter arm.
Preparation items:
Grease: NIPPON GREASE NIGTIGHT LTS No. 2 or equivalent
- Connect the select cable to the transmission main body.CAUTION: Do not apply excessive load while holding the part (a).NOTE: Set the washer before installing the snap pin.
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
- Adjust the select cable free play. Ref. to CONTROL SYSTEMS>SELECT CABLE>ADJUSTMENT .
- Install the center exhaust cover (front). Ref. to EXHAUST (H4DOTC)>REAR EXHAUST PIPE>INSTALLATION .
- Release the shift lock and shift the select lever to the "P range". Ref. to CONTROL SYSTEMS>SELECT LEVER>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .