Active Test: List

NOTE:

Before performing the active test for Auto Start Stop, execution conditions listed below must be met in each item.
*: The restart conditions after stopping the engine are the same as that of "Auto Start Stop restart conditions". Ref. to AUTO START STOP (DIAGNOSTICS)>DATA MONITOR>LIST .

Active test item	Contents	Execution condition
Electric oil pump control (Relay ON/OFF drive)	ON/OFF of the electric oil pump relay (Auto Start Stop) can be set.	CAN communication for engine: Normal Ignition Switch (Auto Start Stop): ON System Voltage (Auto Start Stop): 12.1 V or more Engine Speed (Auto Start Stop): 0 rpm Vehicle Speed: 0 km/h (0 MPH) Under Auto Start Stop control: Other than under control Electric oil pump diagnosis is normal
Electric oil pump control (Pump ON/OFF drive)	Command duty of the electric oil pump (Auto Start Stop) can be set to 10 → 55% (for 120 seconds).	CAN communication for engine: Normal Ignition Switch (Auto Start Stop): ON System Voltage (Auto Start Stop): 12.1 V or more Engine Speed (Auto Start Stop): 0 rpm Vehicle Speed: 0 km/h (0 MPH) Under Auto Start Stop control: Other than under control The value of [Coolant Temp.] is 80°C (176°F) or more
Sub power supply control (ON/OFF Dr.)	DC/DC converter can be set to ON (2 seconds).	CAN communication for engine: Normal Ignition Switch (Auto Start Stop): ON System Voltage (Auto Start Stop): 12.1 V or more Engine Speed (Auto Start Stop): 0 rpm Vehicle Speed: 0 km/h (0 MPH) Under Auto Start Stop control: Other than under control
Engine stop control*	Auto Start Stop can be performed without driving the vehicle.	Auto Start Stop condition is established Ref. to AUTO START STOP (DIAGNOSTICS)>DATA MONITOR .