Module Registration (Update And Verification)

Error message	Cause	Corrective action
Diagnostic Communication Error. End processing An Error occurred in the following ECUs. ECM*, ECM*•••	Attempted to establish communication while the indicated ECM was not connected.	Perform the basic diagnosis for the indicated ECM, and then perform the procedure again from the beginning. If the error persists, replace the indicated ECM.
	Attempted to establish communication while the indicated ECM was not able to communicate.	Turn the ignition switch OFF → ON, and then perform the procedure again from the beginning. If the error persists, perform the basic diagnosis for the indicated ECM. If the same error still persists, replace the indicated ECM.
Battery voltage is low. Check the condition of the vehicle and try again. End processing.	The vehicle power supply voltage is 10 V or less. (CM for voltage measurement: Central gateway control module)	Perform the diagnosis for LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .
The Ignition is OFF. After confirming that the Ignition is ON, please press the Rerun Button.	Attempted to update or verify the key with the ignition switch OFF.	Perform the procedure again with the ignition switch ON.
The Ignition is ON. After confirming that the Ignition is OFF, please press the Rerun Button.	Attempted to continue the key update with the ignition switch ON against the instruction to turn the ignition switch to OFF.	Follow the instructions on the screen.
	The ignition switch was turned to ON before the instruction to do so was displayed on the screen.	Follow the instructions on the screen.
Error occurred during Upload/Download. End processing Error code:	The key management server cannot perform any processing.	After a while, perform module registration (update and verification) again.
	Attempted to perform module registration without performing VIN registration.	Perform VIN registration, and perform module registration (update and verification) again.
Timeout has occurred in Upload/Download. End processing.	No response from the key management server or the response time is too long.	After a while, perform module registration (update and verification) again.
Failed to update MAC Key. End processing. ECM*: Success ECM: Failed to update ECM**: Failed to verify the result •••	Key update failed on the indicated ECM.	Perform the basic diagnosis for the indicated ECM, and then perform the procedure again from the beginning. If the error persists, replace the indicated ECM.
Failed to verification of MAC Key. End processing. ECM*: Success ECM*: Verification failed •••	Key verification failed on the indicated ECM.	Reconnect the indicated ECM connector, and then perform the procedure again. If the error persists, perform module registration (update and verification) again.
There is an ECU that has detected a Key update failure DTC. End processing. ECM*: Not detected ECM*: Detected •••	The communication key of the central gateway control module does not match other ECMs during key verification.	Perform the diagnosis of DTCs B1E00, C1E00 and P1E00. Ref. to CENTRAL GATEWAY (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC B1E00 REGISTRATION FAULT OF AUTHENTICATION UNIT . Ref. to CENTRAL GATEWAY (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC C1E00 REGISTRATION FAULT OF AUTHENTICATION UNIT . Ref. to CENTRAL GATEWAY (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC P1E00 REGISTRATION FAULT OF AUTHENTICATION UNIT .