Engine Wiring Harness: Installation

Set the engine wiring harness, and connect each connector. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>GENERAL DESCRIPTION>COMPONENT>ENGINE WIRING HARNESS .

NOTE:

If the clip is damaged, replace it with a new part .

Before replacing the clip, put an alignment mark (a) on both engine wiring harness and clip to remove the clip, and then align to the alignment mark (a) to attach a new clip to the engine wiring harness .

Courtesy of SUBARU OF AMERICA, INC.

When connecting the intake oil control solenoid RH connector, wiring is possible on either the front or back side of the harness of exhaust camshaft position sensor, etc. (2.0 L model)

Do not cross against the harness of exhaust camshaft position sensor, etc. (2.0 L model)

Courtesy of SUBARU OF AMERICA, INC.

When connecting the intake oil control solenoid LH connector, wiring is possible on either the front or back side of the harness of exhaust camshaft position sensor, etc. (2.0 L model)

Courtesy of SUBARU OF AMERICA, INC.

Install the fuel insulator. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>FUEL INSULATOR>INSTALLATION .
Install the intake manifold assembly. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>INTAKE MANIFOLD ASSEMBLY>INSTALLATION .
Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO)>AIR INTAKE BOOT>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .