Select Cable: Installation

CAUTION:

Check that the protector (b) is set between the clamps (a).
If the protector (b) is offset, set it between the clamps (a).

Courtesy of SUBARU OF AMERICA, INC.

Install a new connector pin to the select lever.
Install the cable bracket.
CAUTION: Be careful not to twist the boot.

Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Set a new clamp on the select lever and secure it by bending the claw.
NOTE: Install it with the claw facing the rear side.
Insert the select cable into the select lever and secure it with the clamp.
CAUTION: Do not apply excessive load while holding the part (a).

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.
Temporarily Install the adjusting nut (rear) to the select cable.
Apply grease to the shifter arm.
Preparation items:

Grease: NIPPON GREASE NIGTIGHT LTS No. 2 or equivalent
- H4DO model
Courtesy of SUBARU OF AMERICA, INC.
- H4DOTC model
Courtesy of SUBARU OF AMERICA, INC.
Connect the select cable to the transmission main body.
CAUTION: Do not apply excessive load while holding the part (a).

Courtesy of SUBARU OF AMERICA, INC.

NOTE: Set the washer before installing the snap pin.

Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Adjust the select cable free play. Ref. to CONTROL SYSTEMS>SELECT CABLE>ADJUSTMENT .
Install the center exhaust pipe (rear). (H4DOTC model) Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>INSTALLATION>CENTER EXHAUST PIPE (REAR) .
Install the center exhaust cover and rear exhaust pipe.
H4DO model:

Ref. to EXHAUST (H4DO)>REAR EXHAUST PIPE>INSTALLATION .

H4DOTC model:

Ref. to EXHAUST (H4DOTC)>REAR EXHAUST PIPE>INSTALLATION .
Release the shift lock and shift the select lever to the "P range". Ref. to CONTROL SYSTEMS>SELECT LEVER>INSTALLATION .