LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2024 >> Outback Base >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension System And Wheel Alignment >> Stabilizer >> Removal >> Stabilizer Bushing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Stabilizer Bushing

  1. Disconnect the ground terminal from battery sensor. (H4DO model) Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Lift up the vehicle.
  3. Remove the under cover front. Ref. to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>REMOVAL .
  4. Remove the front exhaust pipe. (H4DO model) Ref. to EXHAUST (H4DO)>FRONT EXHAUST PIPE>REMOVAL .
  5. Remove the center exhaust pipe (rear). (H4DOTC model) Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>REMOVAL>CENTER EXHAUST PIPE (REAR) .
  6. Remove the bolt and nut, and remove the clamp stabilizer.
    NOTE: The left and right clamp stabilizers differ in shape.
    G14384638Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the rubber bushing stabilizer front.
scientia non olet · About LEMON Manuals