Inspection Mode Z
| DTC | Description & trouble part | Condition | Number of driving cycles on the detecting condition |
|---|---|---|---|
| P0030 | A/F/O2 HEATER CONTROL CIRCUIT BANK 1 SENSOR 1 | - | 2 |
| P0068 | MAP/MAF - THROTTLE POSITION CORRELATION | - | 2 |
| P0101 | MASS OR VOLUME AIR FLOW SENSOR "A" CIRCUIT RANGE/PERFORMANCE | - | 2 |
| P0244 | TURBOCHARGER/SUPERCHARGER WASTEGATE SOLENOID "A" RANGE/PERFORMANCE | - | 2 |
| P04F0 | EVAP SYSTEM HIGH PRESSURE PURGE LINE (CPC2) PERFORMANCE | During acceleration, depress the pedal with the accelerator opening angle of 50% as a reference. | 2 |
WARNING:
When performing inspection mode Z on a public road, pay sufficient attention to the traffic condition and give the highest priority to safe driving.
NOTE:
Perform the inspection mode after warming up the engine except that the engine coolant temperature at engine start is specified.
- Using the Subaru Select Monitor, perform the clear memory of [Engine]. Ref. to COMMON (DIAGNOSTICS)>CLEAR MEMORY .
- Drive according to the drive pattern described below.
(1) 0 km/h (0 MPH) (2) 60 km/h (37 MPH) (3) 88 km/h (55 MPH) (A) Shift the select lever to "P" range, and let the engine idle for 10 seconds or more. (CVT model)
Place the gear shift lever in neutral position, and let the engine idle for 10 seconds or more. (MT model)(B) Accelerate with the throttle half-open to 88 km/h (55 MPH) or more. (C) Drive for 20 seconds or more at 88 km/h (55 MPH) or more. (D) Decelerate the vehicle speed to 60 km/h (37 MPH) with fully closed throttle. (E) Drive for 20 seconds or more at 60 km/h (37 MPH) or less. (F) Accelerate with the throttle half-open to 88 km/h (55 MPH) or more. (G) Stop vehicle with the throttle fully closed. (H) Vehicle speed (I) Sec. - Read the pending code using the Subaru Select Monitor or general scan tool. Ref. to COMMON (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .