Work Support: List

Work Support item	Contents	Remarks
Start count clearing	Used when the starter is replaced.	Execution condition Start Count: Other than 0 CAN communication for engine: Normal Ignition Switch(Auto Start Stop): ON System Voltage(Auto Start Stop): 12.1 V or more Engine Speed(Auto Start Stop): 0 rpm Vehicle Speed: 0 km/h (0 MPH) Under Auto Start Stop control: Other than under control
Start count reading ECU to SSM	Used when the TCM is replaced. Let the Subaru Select Monitor read [Start Count] before removing the used TCM, and then write these [Start Count] after installing a new TCM.	Execution condition CAN communication for engine: Normal Ignition Switch(Auto Start Stop): ON System Voltage(Auto Start Stop): 12.1 V or more Engine Speed(Auto Start Stop): 0 rpm Vehicle Speed: 0 km/h (0 MPH) Under Auto Start Stop control: Other than under control
Start count writing SSM to ECU