LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2025 >> Outback Base >> Repair and Diagnosis >> Engine Performance >> System >> Common Diagnostic Operations >> Unit Registration (Verification) >> Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Unit Registration (Verification): Inspection

List of error messages

Error message Cause Corrective action
Diagnostic Communication Error. End processing An Error occurred in the following ECUs. ECM***, ECM***••• Attempted to communicate with the corresponding ECM when it was not connected. Perform the basic diagnosis of the corresponding ECM, and repeat the procedure from the beginning. If the fault is not fixed, replace the corresponding ECM.
Attempted to communicate with the corresponding ECM when it was in a situation where communication was not possible. Turn the ignition switch OFF → ON, and then perform the procedure again from the beginning. If the fault is not fixed, perform the basic diagnosis of the corresponding ECM. If the fault still exists, replace the corresponding ECM.
It is not a target vehicle for Unit Registration. End processing. A central gateway Control Module with a wrong part number which does not support MAC authentication was installed. Replace the central gateway Control Module with the correct part number and perform registration from the beginning.
NOTE: The wrongly-installed central gateway Control Module is not affected. It can be used again as a service part for another vehicle.
Attempted to verify the key for a wrong vehicle which is not subject to MAC authentication. No corrective action.
NOTE: The wrongly-operated vehicle is not affected. It is OK to proceed to the next operation directly.
Battery voltage is low. Check the condition of the vehicle and try again. End processing. The vehicle power supply voltage is 10 V or less. (control module for voltage measurement: Central gateway control module) Perform the diagnosis for LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .
The Ignition is OFF. After confirming that the Ignition is ON, please press the Rerun Button. Attempted to update or verify the key with the ignition switch OFF. Perform the procedure again with the ignition switch ON.
Failed to update MAC Key. End processing.
ECM***: Success
ECM***: Verification failed•••		 Key verification failed on the indicated ECM. Reconnect the corresponding ECM connector and repeat the procedure. If the fault is not fixed, perform module registration (update & verify) again.
There is an ECU that has detected a Key update failure DTC. End processing.
ECM***: Not detected
ECM***: Detected•••		 The communication key of the central gateway control module does not match other ECMs during key verification. Perform the diagnosis of DTCs B1E00, C1E00 and P1E00.
Ref. to CENTRAL GATEWAY (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC B1E00 REGISTRATION FAULT OF AUTHENTICATION UNIT .
Ref. to CENTRAL GATEWAY (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC C1E00 REGISTRATION FAULT OF AUTHENTICATION UNIT .
Ref. to CENTRAL GATEWAY (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC P1E00 REGISTRATION FAULT OF AUTHENTICATION UNIT .
MAC key update has not been performed. MAC key verification can be performed after MAC key update. End processing. Key verification was performed before key update was performed. Perform module registration (update & verify).
scientia non olet · About LEMON Manuals