Data Link Connector: Note
- This connector is used for Subaru Select Monitor.
- For detailed connection procedures, refer to "Application help".
- 20 minutes after the ignition switch is turned OFF, communication from the data link connector is deactivated. To communicate from the data link connector for diagnosis, perform it with the ignition switch ON.
CAUTION:
Do not connect any tools other than Subaru Select Monitor or general scan tool because the circuit for Subaru Select Monitor may be damaged.
| Terminal No. | Contents | Measuring condition | Standard |
|---|---|---|---|
| (i221) No. 1 | - | - | - |
| (i221) No. 2 | - | - | - |
| (i221) No. 3 | - | - | - |
| (i221) No. 4 ←→ Chassis ground | GND | Always | 10 Ω or less |
| (i221) No. 5 ←→ Chassis ground | GND | Always | 10 Ω or less |
| (i221) No. 6 | CAN-H | - | - |
| (i221) No. 7 | - | - | - |
| (i221) No. 8 ←→ Chassis ground | Ignition power supply | When ignition switch is ON | Battery voltage |
| (i221) No. 9 | - | - | - |
| (i221) No. 10 | - | - | - |
| (i221) No. 11 | - | - | - |
| (i221) No. 12 | - | - | - |
| (i221) No. 13 | - | - | - |
| (i221) No. 14 | CAN-L | - | - |
| (i221) No. 15 | - | - | - |
| (i221) No. 16 ←→ Chassis ground | Battery power supply | Always | Battery voltage |