Ignition Timing

IGNITION TIMING SPECIFICATIONS (Degrees BTDC @ RPM)

Application	Man. Trans.	Auto. Trans.
Swift	6 @ 650	6 @ 650

Fig 1: Swift Ignition Timing Mark Location

Courtesy of SUZUKI OF AMERICA CORP.

Inspect timing indicator and mark on crankshaft pulley. Clean marks if necessary and warm engine to normal operating temperature. Turn all accessories off. Attach timing light to No. 1 spark plug wire. Ensure idle speed is correct.
Disengage monitor coupler at located near ignition coil. See Fig 2 . Connect a jumper wire between terminals "C" and "D". Aim timing light at crankshaft pulley. If timing is not within specification, loosen distributor hold-down bolt and rotate distributor to obtain correct ignition timing. Tighten distributor hold-down bolt and recheck timing.

Fig 2: Swift Monitor Coupler Connector Terminal Identification

Courtesy of SUZUKI OF AMERICA CORP.