LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1990 >> Swift GT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing >> Ignition Checks >> Pick-Up Coil >> Swift SOHC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Swift SOHC

  1. Disconnect pick-up coil connector at distributor. With ignition on, use voltmeter to ensure battery voltage is present at Black/White wire terminal of harness connector. If voltage is low or not present, check ignition fuse circuit. See WIRING DIAGRAMS article.
  2. To test resistance, remove distributor cap, rotor and dust cover. Disconnect pick-up coil Red and White wires from ignitor, noting wire positions for reassembly reference. Connect ohmmeter to Red and White wires and measure resistance. See the PICK-UP COIL RESISTANCE  table. If resistance is not within specification, replace pick up coil.
PICK-UP COIL AIR GAP

Application Clearance In. (mm)
DOHC (1) .008-.012 (.20-.30)
SOHC .008-.016 (.20-.41)
(1) Same as crank angle sensor air gap.
PICK-UP COIL RESISTANCE - Ohms @ 68°F (20°C)

Application Ohms
DOHC (1) 588-882
SOHC 130-190
(1) Same as crank angle sensor.
scientia non olet · About LEMON Manuals