Fuel Injector(s)
- If engine does not run, go to step 3). If engine runs, listen for operational noise from fuel injector(s). Cycling of injectors should increase and decrease with engine speed.
- On TBI models, if fuel is not injected in a conical-shaped pattern while engine is cranking or running, replace injector. Turn ignition off. If fuel leaks from injector at a rate of more than 1 drop per minute with ignition off, replace injector.
- On all models, turn ignition off. Disconnect injector connector. Measure resistance across injector terminals. At 68°F (20°C), resistance should be as specified in FUEL INJECTOR RESISTANCE table.
FUEL INJECTOR RESISTANCE
| Application | Ohms |
|---|---|
| Samurai | 0.8-1.8 |
NOTE:
For fuel system pressure testing and specifications, see BASIC TESTING
article in the ENGINE PERFORMANCE Section.