Fuel Pump Relay
- Turn ignition off. Disconnect negative battery cable. Relay is located under far right side of dash, above ECM. Disconnect relay connector and remove relay. Using an ohmmeter, check continuity between terminals "A" and "B". See Fig 1
. If continuity is not present, go to next step. If continuity is present, replace relay.
- Check resistance between terminals "C" and "D". If resistance is 56-84 ohms, go to next step. If resistance is not 56-84 ohms, replace relay.
- Energize relay by applying battery voltage and ground to terminals "C" and "D". Check continuity between terminals "A" and "B". If continuity is present, relay is okay. If continuity is not present, replace relay.
Courtesy of SUZUKI OF AMERICA CORP.