Ignition System: Distributor: Installation
- To install, reverse removal procedure. If reference mark was not made as described in removal procedure, go to next step.
- Turn crankshaft (clockwise direction) until No. 1 cylinder is at TDC of compression stroke. Align rotor with center of cap bolt hole. Perform STEP 1. See Fig 1
.
- Before installing distributor, ensure "O" ring is in good condition. Replace as required. If new "O" ring is installed, lubricate with engine oil. Install distributor into gearbox. When distributor is fully seated, rotor should point in direction shown in illustration. See Fig 1
(STEP 2).
- Ensure distributor is fully seated. Install distributor hold-down bolt. Adjust ignition timing. See ADJUSTMENTS
article in this section.
Courtesy of SUZUKI OF AMERICA CORP.