Ignition System: Distributor: Installation
- To install, reverse removal procedure. If reference mark was not made as described in removal procedure, go to next step.
- Turn crankshaft (clockwise direction) until No. 1 cylinder is at TDC of compression stroke. Align rotor with center of cap bolt hole. Perform STEP 1. See Fig 1
.
- Before installing distributor, ensure "O" ring is in good condition. Replace as required. If new "O" ring is installed, lubricate with engine oil. On all models, install distributor into gearbox.
- When distributor is fully seated, rotor should point to center of hold-down bolt. See Fig 1
(STEP 2).
- On all models, ensure distributor is fully seated. Install distributor hold-down bolt. Adjust ignition timing. See ADJUSTMENTS
article in this section.
Courtesy of SUZUKI OF AMERICA CORP.