LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1993 >> Samurai JA >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Idle Control System >> Idle Air Control (IAC) >> Swift DOHC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Swift DOHC

  1. Before idle speed/IAC duty is checked or adjusted, ensure all wires and vacuum hoses are connected securely, accelerator cable has some play, valve clearance and timing are set to specification, and all accessories are turned off.
  2. Warm engine to normal operating temperature. Connect tachometer. Using a service wire, connect terminal "D" (ground) to terminal "B" (diagnostic switch). Ensure CHECK ENGINE light indicates a Code 12. Connect duty meter between terminal "D" (ground) and terminal "F" (duty output). If idle speed and IAC duty are not within specification, remove adjusting screw protective cap and adjust idle speed by turning adjusting screw. See ADJUSTMENTS article. Replace IAC solenoid if defective. If IAC solenoid is okay, go to next step.
  3. If vehicle is equipped with A/C, go to next step. If vehicle is not equipped with A/C, replace adjusting screw protective cap and remove service wire.
  4. Turn A/C on, and set heater blower switch to high (maximum) speed. With A/C working properly, ensure idle speed and IAC duty are within specification. If idle speed and/or IAC duty are not within specification, adjust at A/C Vacuum Switching Valve (VSV). See ADJUSTMENTS article. Replace IAC solenoid and/or A/C VSV if defective. Remove service wire. Replace adjusting screw protective cap if removed.
scientia non olet · About LEMON Manuals