LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1995 >> Samurai >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Fuel System >> Fuel Control >> Fuel Injector Circuit Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Injector Circuit Test

  1. Ensure fuel pressure is within specification. Refer to the BASIC TESTING article. If fuel pressure is not within specification, see appropriate FUEL PUMP CIRCUIT TEST under FUEL DELIVERY  .
  2. Check fuel injector operation. See FUEL INJECTOR(S). Turn ignition off. Disconnect injector connector and measure resistance between injector connector terminals. Resistance should be 0.8-1.8 ohms at 68°F (20°C). If resistance is not as specified, replace injector. If resistance is within specification, go to next step.
  3. Disconnect ECM connector "B" from ECM. Measure resistance between connector terminals B8 (Red wire) and B17 (Yellow wire). Resistance should be 0.8-1.8 ohms at 68°F (20°C). If resistance is not as specified, check Red and Yellow wires for short, open or poor connections.
scientia non olet · About LEMON Manuals