Engine Controls - Tests W/O Codes: Introduction
Before diagnosing symptoms or intermittent faults, perform steps in appropriate articles:
- For Esteem, see BASIC TESTING and TESTS W/CODES .
- For Sidekick, see BASIC TESTING - 1.6L and TESTS W/CODES - 1.6L or F - BASIC TESTING - 1.8L and TESTS W/CODES - 1.8L .
- For Swift, see BASIC TESTING and TESTS W/CODES .
- For X-90, see BASIC TESTING and TESTS W/CODES .
Use this article to diagnose driveability problems existing when a hard trouble code is not present.
Symptom checks can direct the technician to malfunctioning component(s) for further diagnosis. A symptom should lead to a specific component, system test or an adjustment.
Use INTERMITTENT SIMULATION under TEST PROCEDURES to locate driveability problems that DO NOT occur when the vehicle is being tested. These test procedures should also be used if a soft (intermittent) trouble code was present, but no problem was found during self-diagnostic testing.
Most intermittent faults are caused by faulty electrical connections or wiring. Perform careful inspection of suspect circuits for:
- Poor mating of coupler halves, or terminals not fully seated in coupler body (backed out).
- Terminals damaged or improperly formed. Reform coupler terminals in problem circuit to increase contact tension.
- Poor terminal-to-wire connection.
For Esteem, see SYSTEM/COMPONENT TESTS .
For Sidekick 1.6L, see SYSTEM/COMPONENT TESTS - 1.6L .
For Sidekick 1.8L, see SYSTEM/COMPONENT TESTS - 1.8L .
For Swift, see SYSTEM/COMPONENT TESTS .
For X-90, see SYSTEM/COMPONENT TESTS .
For specifications, see appropriate articles:
- For Esteem, see ADJUSTMENTS or SPECIFICATIONS .
- For Sidekick 1.6L, see ADJUSTMENTS - 1.6L or SPECIFICATIONS - 1.6L .
- For Sidekick 1.8L, see ADJUSTMENTS - 1.8L or SPECIFICATIONS - 1.8L .
- For Swift, see ADJUSTMENTS or SPECIFICATIONS .
- For X-90, see ADJUSTMENTS or SPECIFICATIONS .